SenTec

PM410 Corrosion Resistant Pressure Sensors

PM410 Corrosion Resistant Pressure Sensor, a low-cost, high-precision, high-reliability, practical product. Especially recommended for corrosive media.

PM410 Corrosion Resistant Pressure Sensors

PM410 Corrosion Resistant Pressure Sensors, a low-cost, high-precision, high-reliability, practical product. Especially recommended for corrosive media.

Corrosion Resistant Pressure Sensors working principle

The corrosion-resistant ceramic pressure sensor has no liquid transfer, and the pressure acts directly on the front of the ceramic diaphragm, causing a slight deformation of the diaphragm. The thick film resistor is printed on the back of the ceramic diaphragm and connected to a Wheatstone bridge (closed bridge). Due to the piezoresistive effect of the varistor, the bridge produces a highly linear voltage signal proportional to the pressure and excitation voltage. The standard signal is calibrated to 2.0/3.0/3.3mV/V depending on the pressure range and is compatible with strain gauge sensors. Through laser calibration, the sensor has high temperature stability and time stability, and the sensor comes with temperature compensation of 0~70 °C.
The high-reliability amplifier circuit and precise temperature compensation convert the measured medium pressure into standard electrical signals such as 4~20mADC or 1~5VDC.

Learn more about SenTec pressure measuring instruments

Parameters

Items

Parameter

Range-0.1MPa…0kPa~10kPa…100MPa
Overload capabilityBelow 10MPa ≤ 2 times full scale
10MPa and above ≤1.5 times full scale
Pressure TypeG (gauge pressure), A (absolute pressure), S (sealed gauge pressure)
Accuracy0.1% (custom), 0.25% (typical), 0.5% (maximum)
Long-term stability±0.1%FS/year (typical), ±0.2%FS/year (maximum)
Zero temperature drift±0.03%FS/°C (≤100kPa), ±0.02%FS/°C (>100kPa)
Sensitivity temperature drift±0.03%FS/°C (≤100kPa), ±0.02%FS/°C (>100kPa)
Compensation temperature0°C~50°C(≤100kPa), -10°C~70°C(>100kPa)
Medium temperature-40°C~80°C
Power supply+12 ~ +36V (Default 24V)
Output Signal4mA~20mA, 0V~10V (output range can be customized)
Load ResistanceCurrent type: ≤ (U-12) / 0.02 (Ω)
Response time≤1(10~90%)ms
Measuring mediumAll corrosive gases, liquids
Diaphragm materialPolytetrafluoroethylene, PTFE or customized
Housing material1Cr18Ni9Ti, Polytetrafluoroethylene, PTFE or customized
InterfaceM20×1.5 or customized
Protection levelIP65 (customizable IP68)

Documents

Take the next step

Get a Quote

Request a quote from us based on your specific requirements

To be a Distributor

If you want to distribute sentec brand in your local area, you can contact us for more.

Installation & Maintain

A group of  professional engineer is here to help your sensor installation & maintenance.